Strong points

  •     Integrated full self-test
  •     Voltage test up to 690 VAC (16 2/3 Hz - 800 Hz) / 750 VDC
  •     Unipolar phase test
  •     Control of phase sequence up to 400 Hz
  •     Continuity test
  •     Removable touch points and cord


The C.A 762 VAT / DDT is the essential tool for any electrician to perform the Voltage Absence Check before any
intervention on an electrical installation connected to the network. Complies with IEC 61243-3 Edition 2, it can be used on any 600 V CAT IV indoor / outdoor installation. In order to meet the normative and legislative requirements of some countries, there are 2 references with or without IP2X accessories.

The C.A 762 has a redundant safety system in case of power failure, the "LED ELV" flashing as soon as
the voltage is greater than 50 VAC / 120 VDC. The C.A 762 complete Autotest ensures the control of the electrical circuits, the power supply, the displays, the good condition of the test leads.
The touch point and the cords are removable. The C.A 753 measuring accessory (optional) allows quick and easy control of 2P + T sockets.

Characteristics :

  •       CAT IV 600V
  •       IP65
  •       Full self test
  •       Voltage detection, LED display 12 ... 690 VAC / 750 VDC
  •       Automatic indication of the nature of the voltage (AC or DC) and indication of the polarity
  •       Unipolar phase control (single contact)
  •       Bipolar control of the order of phases "2-wire method = a third hand is not required"
  •       Continuity test with audible and visual indication (R <100 Ω)
  •       Extended continuity test with visual indication for R <2 kΩ, 60 kΩ and 300 kΩ
  •       Automatic continuity check if no voltage presence detection
  •       Conforms to EN 61243-3 Ed.2009, EN 61243-3 Ed.2010, DIN VDE 0682-401 Ed.2011
  •       Cord and tacks are removable
  •       Comes complete and ready to use